You can install the Aladdin XTREME with the PIN-HEADER (included in
the parcel) or direct soldering to the motherboard (on the LPC bus).
(Hint: we recommend the easyer PIN-HEADER installation. With this installation
can you easy remove the chip from the mainboard) |
| |
PIN Header Installation
|
| This is the area you will be working with. This is the LPC port that
you will be soldering the pin header to. As you can see the holes are
clean and ready to go. Only older machines have solder in these holes
(v1.0 - v1.1), all the newer machines are all unfilled. To remove solder
from filled holes - simply put some fresh solder on each hole and heat
it up a little them simply use the Multicore No-Clean Desolder Wick (included
in delivery). The entire process takes less than 5 minutes. |
|
|
|
First remove the second pin (pull it out or cut it off) and place the
pin header into the LPC port as demonstrated below.
|
|
|
|
Turn the board over to solder. The diagram clearly shows how simple and clean
this procedure actually is. Even if you take your time you'd be very slow
if it took longer than a minute. We recommend you use our solder (included
in delivery) the for a nice even flow of solder. |
|
|
|
| |
Direct soldering to the LPC
BUS
|
|
!!! Don´t forget to solder the 9 points to
the LPC bus !!! |
|
| |
Aladdin XTREME installation
|
 |
| Bridge the "X" point with the "D0" point
if the ModChip doesn´t turn on and
boots with the original BIOS (some XBoxe consoles only). |
|
