| This is the area you will be working with. This is the LPC
port that you will be soldering the pin header to. As you can see the
holes are clean and ready to go. Only older machines have solder in
these holes (v1.0 - v1.1), all the newer machines are all unfilled.
To remove solder from filled holes - simply put some fresh
solder on each hole and heat it up a little them simply use the Multicore
No-Clean Desolder Wick (included in delivery). The entire
process takes less than 5 minutes. |
|
|
First place the pin header into the LPC port as demonstrated below.
|
|
|
Turn the board over to solder. The diagram clearly shows how simple
and clean this procedure actually is. Even if you take your time you'd
be very slow if it took longer than a minute. We recommend you use our
solder (included in delivery) the for a nice even flow of solder. |
|
|
