This is a simple instruction of using SwapMagic3.3 on the latest PS2 console SCPH-7000x.

By using the PSTwo-FIX, you don't need to open your console to do modification, that means you will not void the warranty.

First open the disk drive opening and locate the two disk sensors and the break for disk. You need to install two small activator to activate the switches and a plug to stop the disk break.


1) The first micro switch for the PSTwo-FIX A is at the small hole near the right corner.

2) The disc break for the PSTwo-FIX B locate at the inner right side near the disc concave.

3) The second micro switch for the PSTwo-FIX C is at the small hole near the right corner.

The first micro switch for the PSTwo-FIX A is at the small hole near the right corner:

Here see you the position from the first micro switch. Push the PSTwo-FIX A into the sensory hole (we recommend to fix the PSTwoFIX A with an adhesive tape).
On this picture see you the PSTwo-FIX A when it was installed correctly.

The disc break for the PSTwo-FIX B locate at the inner right side near the disc concave:

On this picture see you the position for the PSTwo-FIX B in unmodified form.
Move the disc break switch with the help of a small pen or a small scredriver to the right and hold it in this position.
Put the PSTwoFIX B in the left hole from the disc break switch.
On this picture see you the PSTwo-FIX B when it was installed correctly.

The second micro switch for the PSTwo-FIX C is at the small hole near the right corner:

On this picture see you the position for the PSTwo FIX C in unmodified form.
Move PSTwoFIX C as shown in the picture in the direction of the hinge. Attention to the orientation as shown below:
Put PSTwo FIX C in the gap between the metal clip and the hing.
Push PSTwoFIX C with the help from a small screwdriver downwards. When the PSTwo-FIX C is laying flat your console is ready for use.

The PSTwo-FIX can be left in your console because it works with original CD / DVD discs without any problems. The cover can be left open or closed when playing your games.

If all switches had been pressed than you can place the Swap Magic 3.3 disk onto the driver and run it for a while.